Surgical management of non-small cell lung cancer (NSCLC) invading chest wall is the combination of pulmonary resection, lymphadenectomy and chest wall resection and reconstruction. Hitherto the surgical procedures include combination of thoracotomy and video-assisted thoracoscopic surgery (VATS), thoracotomy, and VATS. The result of the surgery leads to a defect in the chest wall. Therefore, the requirements of the technique and material are relatively high with no consensual standard. This review describes the definitions, indications, materials, prognostic factors, and recent progress in surgical techniques.
ObjectiveTo explore the effectiveness of the modified designed bilobed latissimus dorsi myocutaneous flap in chest wall reconstruction of locally advanced breast cancer (LABC) patients.MethodsBetween January 2016 and June 2019, 64 unilateral LABC patients were admitted. All patients were female with an average age of 41.3 years (range, 34-50 years). The disease duration ranged from 6 to 32 months (mean, 12.3 months). The diameter of primary tumor ranged from 4.8 to 14.2 cm (mean, 8.59 cm). The size of chest wall defect ranged from 16 cm×15 cm to 20 cm×20 cm after modified radical mastectomy/radical mastectomy. All defects were reconstructed with the modified designed bilobed latissimus dorsi myocutaneous flaps, including 34 cases with antegrade method and 30 cases with retrograde method. The size of skin paddle ranged from 13 cm×5 cm to 17 cm×6 cm. All the donor sites were closed directly.ResultsIn antegrade group, 2 flaps (5.8%, 2/34) showed partial necrosis; in retrograde group, 6 flaps (20%, 6/30) showed partial necrosis, 5 donor sites (16.7%, 5/30) showed partial necrosis; and all of them healed after dressing treatment. The other flaps survived successfully and incisions in donor sites healed by first intention. There was no significant difference in the incidence of partial necrosis between antegrade and retrograde groups (χ2=2.904, P=0.091). The difference in delayed healing rate of donor site between the two groups was significant (P=0.013). The patients were followed up 15-30 months, with an average of 23.1 months. The appearance and texture of the flaps were satisfactory, and only linear scar left in the donor site. No local recurrence was found in all patients. Four patients died of distant metastasis, including 2 cases of liver metastasis, 1 case of brain metastasis, and 1 case of lung metastasis. The average survival time was 22.6 months (range, 20-28 months).ConclusionThe modified designed bilobed latissimus dorsi myocutaneous flap can repair chest wall defect after LABC surgery. Antegrade design of the flap can ensure the blood supply of the flap and reduce the tension of the donor site, decrease the incidence of complications.
ObjectiveIn this study, three-dimensional printed (3DP) titanium implants were used for skeletal reconstructions after wide excision of chest wall. 3DP titanium implants were expected to provide a valid option with perfect anatomic fitting and personalized design in chest wall reconstruction.MethodsThere were 13 patients [mean age of 46 (24-78) years with 9 males and 4 females] who underwent adequate radical wide excision for tumors and chest wall reconstruction using 3DP titanium implants. Surgical data including patient demographic characteristics, perioperative clinical data and data from 1-year follow-up were collected and analyzed.ResultsSix patients of rib tumors, six patients of sternal tumors and one patient of sternal pyogenic osteomyelitis were finally selected for the study. The chest wall defect area was 221.0±206.0 cm2. All patients were able to maintain the integrity of the chest wall after surgery, and no abnormal breathing was found, achieving personalized and anatomical repair. Thirteen patients were successfully discharged from the hospital. Two patients developed pneumonia in the perioperative period. During the follow-up period in the first year after surgery, no implant related adverse reaction was observed, including implant rupture, implant shift, rejection reaction and allergies. One patient had wound ulcer after chemotherapy. Three patients had tumor recurrence, with the recurrence rate of 25.0%. Two patients died of tumor recurrence, with a mortality rate of 16.7%.Conclusion3DP titanium implant is a safe and effective material for chest wall reconstruction.
ObjectiveTo investigate the application of expanded anterolateral thigh myocutaneous flap in the repair of huge chest wall defect. Methods Between August 2018 and December 2020, 12 patients, including 4 males and 8 females, were treated with expanded anterolateral thigh myocutaneous flap to repair huge complex defects after thoracic wall tumor surgery. The age ranged from 28 to 72 years, with an average of 54.9 years. There were 4 cases of phyllodes cell sarcoma, 2 cases of soft tissue sarcoma, 1 case of metastatic chest wall tumor of lung cancer, and 5 cases of breast cancer recurrence. All cases underwent 2-7 tumor resection operations, of which 3 cases had previously received lower abdominal flap transplantation and total flap failure occurred, the other 9 cases were thin and were not suitable to use the abdomen as the flap donor site. After thorough debridement, the area of secondary chest wall defect was 300-600 cm2; the length of the flap was (24.7±0.7) cm, the width of the skin island was (10.6±0.7) cm, the length of the lateral femoral muscular flap was (26.8±0.5) cm, the width was (15.3±0.6) cm, and the length of the vascular pedicle was (7.9±0.6) cm. Results The myocutaneous flaps and the skin grafts on the muscular flaps were all survived in 11 patients, and the wounds in the donor and recipient sites healed by first intention. One male patient had a dehiscence of the chest wall incision, which was further repaired by omentum combined with skin graft. The appearance of the reconstructed chest wall in 12 patients was good, the texture was satisfactory, and there was no skin flap contracture and deformation. Only linear scar was left in the donor site of the flap, and slight hyperplastic scar was left in the skin harvesting site, which had no significant effect on the function of the thigh. All patients were followed up 9-15 months, with an average of 12.6 months. No tumor recurrence was found. ConclusionThe expanded anterolateral thigh myocutaneous flap surgery is easy to operate, the effective repair area is significantly increased, and multiple flap transplantation is avoided. It can be used as a rescue means for the repair of huge chest wall defects.
Because of the characteristics such as accurate, efficient and individuation, 3D printing is being widely applied to manufacturing industry, and being gradually expanded into the medical field. Diseases of chest wall is a common type in thoracic surgery, and surgery is a proper treatment to this kind of disease. For the past few years, 3D printing is being gradually applied in surgery of chest wall diseases. The article mainly makes a statement of two parts that including the possibility to apply 3D printing including chest wall reconstruction and chest wall orthopedic, and to analyze the possibility and application prospect of applying 3D printing to the chest wall disease.
Objective To explore the effectiveness of lobulated pedicled rectus abdominis myocutaneous flap to repair huge chest wall defect. Methods Between June 2021 and June 2022, 14 patients with huge chest wall defects were treated with radical resection of the lesion and lobulated pedicled rectus abdominis myocutaneous flap transplantation for reconstruction of chest wall defects. The patients included 5 males and 9 females with an average age of 44.2 years (range, 32-57 years). The size of skin and soft tissue defect ranged from 20 cm×16 cm to 22 cm×22 cm. The bilateral pedicled rectus abdominis myocutaneous flaps in size of 26 cm×8 cm to 35 cm×14 cm were prepaired and cut into two skin paddles with basically equal area according to the actual defect size of the chest wall. After the lobulated pedicled rectus abdominis myocutaneous flap was transferred to the defect, there were two reshaping methods. The first method was that the skin paddle at the lower position and opposite side was unchanged, and the skin paddle at the effected side was rotated by 90° (7 cases). The second method was that the two skin paddles were rotated 90° respectively (7 cases). The donor site was sutured directly. Results All 14 flaps survived successfully and the wound healed by first intention. The incisions at donor site healed by first intention. All patients were followed up 6-12 months (mean, 8.7 months). The appearance and texture of the flaps were satisfactory. Only linear scar was left at the donor site, and the appearance and activity of the abdominal wall were not affected. No local recurrence was found in all tumor patients, and distant metastasis occurred in 2 breast cancer patients (1 liver metastasis and 1 lung metastasis). Conclusion The lobulated pedicled rectus abdominis myocutaneous flap in repair of huge chest wall defect can ensure the safety of blood supply of the flap to the greatest extent, ensure the effective and full use of the flap tissue, and reduce postoperative complications.